8
E N R O L L & P R O G R A M D E V I C E S
3.3 Enroll & Program Wireless Keys
(WLS909)
For wireless keys to work on the system, you need to
enroll them and then program the function buttons.
Wireless keys are not assigned to zones and require
no zone programming. You can enroll up to 16
wireless keys on the system.
Enroll Wireless keys
1. At a system keypad, enter [
✱
][8][Installer’s code]
to go to the Installer’s Programming section.
2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to assign the
wireless key a slot. These numbers correspond
to wireless key numbers 01-16.
4. Enter the key’s ESN. The entry
must be six digits.
If an older key with a 5-digit ESN is being enrolled,
add the digit [0] to the beginning of the ESN. (E.g.
ESN=61234, enter 061234)
5. The key is now enrolled on the system. Record
the serial number and the assigned slot number
in the programming worksheets in the back of this
manual.
6. Repeat steps 3 - 5 until all wireless keys have
been enrolled.
7. (PC5010 and PC5015 only)
(PC5010 and PC5015 only)
(PC5010 and PC5015 only)
(PC5010 and PC5015 only)
(PC5010 and PC5015 only) By default, all
wireless keys are assigned to Partition 1. To assign
keys to Partition 2, enable the appropriate options
in programming sections [91] and [92].
NOTE: A wireless key can only be assigned to one
partition.
8. To exit press [#].
Program the WLS909 Function Buttons
WLS909 wireless keys have four programmable
function buttons. You must program a set of four
functions for the buttons before any keys will work.
After the functions are programmed, when you press
and hold one of the four buttons for two seconds, the
system will execute the programmed function.
For systems not using partitions:
program the
function buttons in section [59]. All wireless keys will
have the same four functions.
For systems using 2 partitions (PC5010 and
PC5015 only):
all wireless keys assigned to Partition
1 will have the four functions programmed in section
[59]. All wireless keys assigned to Partition 2 will
have the four functions programmed in section [60].
For example, if function button 1 in Section [59] is
programmed for Stay arming, then pressing the first
button on wireless keys assigned to Partition 1 will
Stay arm Partition 1.
NOTE: Wireless keys will not work when the partition
they are assigned to is being accessed for zone
bypassing or programming.
1. At a system keypad, enter [
✱
][8][Installer’s code].
2. Enter programming section [804].
3. Enter programming section [59] for keys assigned
to partition 1, or [60] for keys assigned to partition 2.
4. For each of the 4 function buttons, enter the 2-
digit number of the function you want to select.
See the programming worksheets for a list of
function key options.
5. Record your programming choices in the
worksheets in the back of the manual.
6. To exit press [#].
3.4 Identified Wireless Keys
Reporting by the system of openings/closings by
individual wireless keys and command output
[Q][7] activation by wireless key buttons may be
supported on certain control panels. To do this, the
system will reserve access codes 17 – 32 for
wireless keys 01-16 respectively. You must program
one access code for each wireless key (using
[Q][5] access code programming) for this feature to
work correctly.
Refer to your system Installation Manual for
information on access code programming.
