DSC GSM 1000, Руководство по установке

Страница: 15 / 24

13
4.1.2 Disconnecting GSM 1000 Programmer
Step 1 Step 1 Step 1 Step 1 Step 1 Remove the BLACK and RED wires from the standby battery.
Step 2 Step 2 Step 2 Step 2 Step 2 Disconnect the modular cord of the Programmer Unit from the GSM 1000.
Step 3 Step 3
Step 3 Step 3
Step 3 Remove Jumper J4 from GSM 1000 module.
Step 4 Step 4
Step 4 Step 4
Step 4 Make sure that the SIM card is securely seated in its socket and the holder is latched.
Step 5 Step 5
Step 5 Step 5 Step 5
Observe the proper flashing rate of the red LED. It should only flash once every ten seconds.
Note: Unplug the Programmer from the GSM 1000 when finished programming. The GSM 1000 will not
operate when the Programmer is plugged in.
4.1.3 Using a PC (Personal Computer)
Programming can also be done using a personal computer and a GSM 1000 programming cable (Order
at Sur-Gard Part #: 19000855). For hook up and details please refer to Programming Hookup diagram.
Use the following setup:
Start ‘Hyper Terminal’ software under Windows and set the communication options to:
• Baud rate: 1200
• Parity: even • Data bits: 7 • Stop bit: 1 • Flow control: none
Power up the GSM 1000 module and then connect the GSM 1000 Programming cable to J1 (RJ45 socket).
Note: Jumper J4 should be ON when programming the unit via PC or GSM 1000 Programmer. Remove
jumper when programming is complete.
4.2 Setting up the GSM 1000 Programmer/PC