6. Remove the separator by pulling it straight out.
Make note of the separator positioning before
removing so that it can be re-installed correctly.
Clean these parts with warm, soapy water and let
them dry thoroughly
(Fig 3)
.
SPILL-PROOF
dispenser insert
Air Filter
Separator
Reservoir
Fig 3
8. Wearing rubber gloves, wipe the inside of the reservoir with a clean cloth or soft
brush. Use caution as the water may still be hot to the touch
(Fig 5)
.
9. Completely drain the water from the reservoir by dispensing the water through
the hot and cold spigots into a container.
10. Repeat steps 7 and 9 to completely flush the dispenser. It is not necessary to wipe
the inside of the reservoir a second time.
11. Replace the separator and the no-spill dispenser insert. Wipe down the cooler and
the surrounding area to dry any water spills.
12. Wash your hands thoroughly with soap and water for at least 20 seconds. Install
a full water bottle on the dispenser. Plug it in and turn on the hot tank heater
switch located at the rear of the dispenser.
Fig 4
Fig 5
7. Boil a gallon of water and carefully fill the reservoir ¾ full. Let the water sit for 5
minutes
(Fig 4)
.
TIP:
Always use caution when handling hot water. We recommend
boiling partial quantities in a small pot or tea kettle to minimize
risk of spilling while pouring into the reservoir.
TM
hot and cold
©2020 DS Services of America, Inc.