20
For models JM44 and JM54, adjust the Supply shaft tension properly (page 17).
NOTE: We recommend placing a „Tail Board‟ behind the last production board (this can be
the same board used as a leader board/starting panel). This is especially important when
pre-coating foam board.
Mounting a Graphic to a Pre-Coated Board
1.
Adjust the rollers for proper pressure (see Page 17).
2.
Expose the adhesive on the board by folding back approximately 1” (2.5cm) of the
release liner.
3.
Using the folded-back release paper as a temporary support bridge, align the print onto
the board and then proceed to “tack” (stick or press down) the leading edge of the print
onto the exposed adhesive.
4.
Run a
Leader Board
of the same thickness as your mounting board through the rollers
so that the back edge of the Leader Board is at the nip of your machine.
