Druck DPI 800, Инструкция по эксплуатации

Страница: 16 / 270

Copyright 2003 Baker Hughes Company.
12 | DPI 800/802 Instruction Manual–English
4. Before you disconnect the instrument, isolate and bleed the system.
Figure 2: Example Configuration - Measure pressure
The examples in Figure 2 shows:
• How to measure one or two pressures in a system.
• How to measure pressure difference.
Note: ∆P = High range IDOS - Low range IDOS. If Pressure (p2) > Pressure (p1), the result is
negative.
2.4 Leak Test
To do a leak test on a pressure system:
1. Connect the instrument (Figure
3) and, if necessary, adjust the
Set Up
(Table 1).
2. Select an applicable leak test from Select Task (Table 2/Table 3) and, if necessary, adjust
the Settings (Table 4).
3. Set the period for the leak test (Table 4).
4. If necessary, do a zero correction (Table 4).
5. To start the leak test, select Start (

). When the test is finished, the instrument calculates
the leak rate in the applicable units/minute.
P
MENU
OK
HOLD
ESC
P
5.003
P1-P2
MENU
OK
'
'
P1 ... g
P1 30 ... g
15.006
30 ... g
MENU
OK
10.003
20 ... g
p1
p2
P1 P2
p1
p2
Settings Settings
a) P1 and/or P2 b) P1 - P2