9711-26020-0001
Exp o rt Co n tro lle d – S e e P a g e 3
Rev D
SECTION 8
ARMOR X10gx Tablet Computer
SECTION 9
BATTERY MANAGEMENT
Page 199 of 234
ARMOR X10gx Tablet Computer
Wh a t to Do fo r a n Ove rly Dis c h a rg e d Ba tte ry
The X10gx has an internal Level 2 smart battery charger. One of the features of this charger is
that it will attempt to recover a battery that has been too deeply discharged (<3%). This is done
by applying a trickle current of 80 milliamps for about 3 minutes. This process normally injects
enough energy into the battery to allow normal re-charging to begin. If the recovery process is
successful, the 20% LED will begin flashing or be on steady. Allow the battery to charge
normally.
If the 20% LED fails to start flashing, perform the recovery procedure in Table 31.
Table 31. Recover an Overly Discharged Battery.
STEP
ACTION
1.
Remove the battery and wait 5 seconds.
2.
Reinstall the battery and allow it to charge.
3.
If the battery does not respond, repeat the above steps up to a maximum of five
times.
4.
If the battery still fails to start charging, it will have to be replaced.
