Dromex: Unit 1, 1 Blase Road, New Germany, 3620, South Africa
T. +27(31) 713 1960 E. [email protected]
www.dromex.co.za
Donning/Insert the earmuff
The ear defender must only be attached to the helmet using the correct adapter kit.
Ensure ear muffs defenders are fitted, adjusted, maintained and regularly inspected
to ensure no wear or damage is present.
To connect the ear defender to the helmet, insert the inter-ex helmet mounting
bracket (fig1) into the helmet slot (fig2).
Attach the inter-ex ear muff bracket into the helmet mounting bracket in either
position "A" (fig3) or position "B" (fig4) so that the ear muff will will have the best fit
and line up the ear muff with the ear.
Locate the inter-ex bracket firmly into the helmet mounting bracket (fig5) and
rotate the ear muff into position (fig6)
Position the ear defender cups at the bottom of the arms. Place the helmet on the
head and adjust to get a comfortable fit. Pull the side arms in against the head until
they locate and slide the ear cups up the side arms until the ears fit comfortably
inside the cups.
Donning/Insert the visor
To insert the new face shield, firstly remove the protective film, then start at one end
and insert the face shield into the locating slot with the hole lined up with the
carrier pin.
Push the face shield until it locates onto the carrier pin.
Repeat this step for all 3 locating holes. Re-attach. Please ensure hands are clean
and free of dirt as this could scratch the visor.
Donning/ Inserting the eye protector onto helmet
The visor should only be fitted to the DROMEX inter-ex ear muff assembly.
Insert the brow guard locating arm into the locating slot (fig8) of the Inter-ex
earmuff bracket until the assembly is in position and the tab locked (fig9).
The entire face shield and ear muff assembly should be connected to the helmet
when ready to use (fig10).
Doffing/Removal of face shield
To replace the face shield, remove the carrier from the hard hart assembly.
Hold the face shield assembly (fig 11)and press the face gently until the shield
releases from the carrier locating pin (fig 12).
Repeat this for all three location pins until the face shield is separate from the
carrier.
4
LDPE
7
ABS
• Visor
• Visor carrier
Disposal
All industrial waste should be disposed of correctly according to local
regulations and good disposal practice. Hearing protective devices should
be disposed of considering the hazardous substance they were used for.
Please consider recycling.
