05/02/17
L: instructions/all updated instructions/PDF/
b.
Align the partially inserted perch rod with the exit hole and push down on the feeder until the perch rod extends equally
on both sides of the tube. Finish tightening the Phillips screw on the port. Do not overtighten the Phillips screw as this
will cause the tube to crack at the port when the tube expands in the hot weather.
5.
Place the base on the feeder and insert both Phillips screws through the base into the holes in the hanger bar and tighten.
Note:
The slot on the end of the hanger bar is used to align the holes in the hanger bar with the base screws using a flat
tipped screwdriver.
6
.
Slide the universal cover and then the spring clamp down the tube approximately 1” below the holes for the bail rod.
7. Install the bail rod in the small holes at the top of the tube. Place the top cap with the bail wire and B-7 washers on the feeder,
inserting the ends of the bail wire through the holes in the bail rod. Use pliers to bend the ends of the bail wire to a 90
angle.
Attaching Cage
1.
Place the feeder inside the cage positioning all 4 small outer fins, located underneath the universal cover, inside the rim of the
cage. This will properly position the feeder for installation of the black threaded wing nut. The universal cover may require
adjusting by moving the spring clamp slightly higher or lower on the tube until the base of the feeder meets the bottom of the
cage.
2.
Invert the cage with the feeder. Align the threaded hole in the base of the feeder, with the hole in the bottom of the cage using
your finger. Once aligned, replace the black threaded wing nut.
3.
Gently push down on the spring clamp until the universal cover is resting snuggly on the top of the cage.
Important: Slide both B-7 washers upward to the center of the bail wire before lifting the top cap for filling or when
lowering the bail wire.
B-7F Feeder components
Cage components
www.drollyankees.com
Customer Service:
(860) 779-8980 or (800) 352-9164
Bail Wire
B-7 Washer
Top Cap
Bail Rod
Tube
Port
Perch Rod
Hanger Bar
Baffle
Base
Spring Clamp
Universal Cover
Cage
Wing Nut
bottom of cage