assembly
adjustments
Footrests
Raise or lower footrests by loosening Allen screws (H),
place at desired position and tighten Allen screw. Angle
of footplate can be adjusted by removing Allen screw
(I), removing footplate and replacing at desired position.
Replace Allan screw. Footrest can be swung away by
pushing release latch (J).
Abductor
Abductor can be removed or adjusted in depth by pulling
knob (K) down and pulling/pushing abductor assembly.
K
4. Mount seat and then back by positioning grey frame
clips (D) on the seat base and backposts and clicking
them into place.
5. Place four black seat and back brackets (E) (image
on next page) over frame and fasten with wing nuts
provided.
6. Mount right and left footrests by placing hangar (F)
over hangar pins (G), rotate footrest inward until it
locks onto frame.
1. Open frame by pulling right and left side apart and
pushing down on the cross brace until fully extended.
2. Install right and left rear wheels by pushing the quick
release button (A) on the axles and sliding it into the
axle sleeve (B) (image on next page) until it locks. To
remove, push the quick release button and pull out
from axle sleeve.
3. Lift up right and left push handle (C) until it clicks into
place.
A
D
H
I
J
G
F
D
C
