8
10
9
7
1-2c
m
''
(0.4-0.8
)
1~
2cm
(0
.4~
0.8
inc
h)
22~
36c
m
8.6
~14
.2 i
nch
)
Ma
in
Ar
ter
y
LEF
T A
RM
IN
DEX
SYS
DIA
PUL
SE
M
SET
mmH
g
mm
Hg
/min
STAR
T
STOP
SYS
DIA
PUL
SE
M
SET
mmH
g
mmH
g
/min
STAR
T
STOP
Unit Illustration
Contents
1. Monitor Unit
2. Owner’s Manual
4. Storage Bag
5. Medical AC Adapter(DC6.0 V,600mA)
(recommended, not provided)
3. Arm Cuff
Important Testing Guidelines
1. Avoid eating, exercising, and bathing for 30 minutes prior to testing.
2. Sit in a calm environment for at least 5 minutes prior to testing.
3. Do not stand while testing. Sit in a relaxed position while keeping your arm level with
your heart.
4. Avoid speaking or moving body parts while testing.
5. While testing, avoid strong electromagnetic interference such as microwave ovens and
cell phones.
6. Wait 3 minutes or longer before re-testing
7. Try to measure your blood pressure at the same time each day for consistency.
8. Test comparisons should only be made when monitor is used on the same arm, in the
same position, and at the same time of day.
9. This blood pressure monitor is not recommended for people with severe arrhythmia.
10. Do not use this blood pressure monitor if the device is damaged.
Any blood pressure recording can be affected by the following factors:
1. The position of the subject, his or her physiologic condition;
2. The performance and accuracy of the device;
3. Cuff size: too small cuff (bladder) will produce a higher blood pressure value than usual,
too big cuff (bladder) will produce a lower blood pressure value;
4. Measuring position does not keep level with your heart;
5. Speaking or moving body parts while testing;
6. Not relaxing for about 5 minutes before taking the measurement.
Quick Start
Unit Operation
1. Install batteries. (See Figure A )
2. Insert cuff air plug into the left side of monitor unit. (See Figure B)
Figure A
Figure B
3. Remove thick clothing from the arm area.
4. Rest for several minutes prior to testing. Sit down in a quiet place comfortably, back and
arm support on a desk or table, with your legs uncrossed, your arm resting on a firm
surface and your feet flat on the floor. (See Figure C )
Figure
C
5. Apply cuff to your left arm and middle of the cuff at the level of your heart. Bottom of cuff
should be placed approximately 1-2cm (1/2") above elbow joint. (See Figures D&E)
Figure D
Figure E
6. Press “START/STOP” Button to start testing.
Battery Installation
Slide battery cover off as indicated by arrow.
Install 4 new AA alkaline batteries according to polarity.
Close battery cover.
AC Adapter jack is on the right side of the monitor. Medical AC adapter (DC 6.0 V, 600mA)
can be used with the device (recommended, not provided). The adapter connect pin
should be positive inside and negative outside with a 2.1mm coaxial joint.
Do not use another type of AC adapter as it may harm the unit.
AC Adapter Jack