Trouble shooting Bellavita handset
Trouble shooting Bellavita Handset
Stand 11/2009
Page 1 of 2 / HJR
Failure
Possible causes
Trouble shooting
Led didn’t flash
Accupack unplugged from
board inside
Replace handset
LED is flashing, but bathlift
didn’t move.
Coiled cable overstretched
and thereby unplugged
Replace handset
LED twinkle green during
pressing the UP-button, but
the bathlift don`t move
Handset is not connected
correct – Alert function
Switch off handset
, connect
correct and switch on again.
LED twinkles red (amber) in
spite of fully accu.
Board in a wrong mode
Switch off handset and
disconnect, the connect again
and switch on.
Here you can also do the
selftest in case of insecurity,
the test must always start with
a green flashing LED !
The handset should always be switched off before connecting (as well as for use at the
bathlift or charging). !
While charging the LED
twinkles red
Board in a wrong mode
Disconnect power supply,
Switch on handset- and then
switch off. Connect now first
handset and power supply
and then connect power
supply with the socket.
While charging the LED
twinkles green
Board in a wrong mode
See above
LED didn`t flash while
charging
Power supply defective or bad
connected
Check connection, if
necessary replace power
supply.
Note:
If there are still problems with the charging mostly a reset will help. To make a
reset, please do twice the selftest but without the relais test, this means switch off
the handset when the red Led is flashing !
Requirements fort he selftest: The accu`s must be charged so that the LED shows green or
amber, not red ! Also the handset should not be connected neither with the bathlift nor with
the power supply.
How to do the selftest, see next page:
