CMS Electric Scooter
Page 8 of 16
Owner’s Handbook (Code: CMS_IFU 05/18)
6.
BATTERY CHARGING AND CARE
The battery pack can be charged either when it is
installed or removed from the scooter.
To Charge
1.
Switch the key ignition off.
2.
Plug the charger’s power cord in to the mains.
3.
If required, remove the battery pack (see next
section for details)
4.
Pull the end of the rubber cover on the battery
pack (1 – as shown in photo). Then connect the
charger’s round plug in to the charging socket
(2)
5.
Switch on the plug socket at the mains.
The battery pack can be charged on-board the
scooter (as shown above). Alternatively, the battery
pack can be removed from the scooter and the
battery pack can be charged away from the scooter.
To Remove the Battery Pack
1.
Switch the scooter off at the ignition.
2.
Lift the scooter battery pack up by the
handle (see below).
To Install the Battery Pack.
1.
Remove the charger from the battery pack.
2.
Drop the battery pack in to the void on the
scooter.
3.
Press down lightly on the battery pack to
ensure it is securely installed.
Charger Light
The charger light will illuminate orange to
indicate the batteries are charging. The charging
duration is about 8 hours, however a 12 hour
charge is recommended for optimum
performance. The orange light will turn green
when charging is complete.
Ensure that the charger is removed from
the mains and the scooter or battery pack
after charging. Failure to do this may
flatten the battery.
Do not remove the battery pack whilst
the scooter is switched on.
