Page 8 of 12
XS Aluminium Wheelchair (2021-02 rev1)
disassembly and storage
This wheelchair has a number of quick release components and the
wheelchair frame is easily foldable. This facilitates a light carry weight and
minimises storage space required. To disassemble for storage, transport or
maintenance, follow the steps below. To reassemble components, reverse
these instructions.
2. Armrests
There is a lever towards the front of each
armrest to move them, similar to the
backrest levers. Push the levers to release
the armrests and flip them upwards.
To remove the armrests, flip them
upwards, pull the lever at the back (1) of
the
Removing armrests
image and pull
upwards on the tube frame (2).
3.
Half Folding Back
Follow the previous instructions to fold the back.
4. Footrests
Follow the previous instructions to remove or swing out the footrests.
5.
Folding the wheelchair
Remove the seat and back cushions. Then grab the centre of the front and
rear edges of the seat sling. Pull upwards on the seat sling and the
wheelchair should naturally fold up.
Note: The wheelchair may be folded and stored in a motor vehicle.
The wheelchair should be stored in a dry environment, away from direct
sunlight.
Removing
armrests
1
2
1.
Quick release wheel
To remove the rear wheels, push the button
in the centre of the wheel hub, (shown on the
Quick release button
diagram in grey), and
slide the wheel and axle from the frame.
To reattach, push both parts into the frame
until the wheel is secure.
Quick release
button
