Emitters
To bring the water into your planting area, the Sprinkler to Drip Conversion Kit uses Soaker
Dripline (DSD12), ¼” polyethylene tubing with built
-
in emitters spaced every 12”. In addition, a
variety of ¼” fittings—
transfer barbs, tees, elbows, and hold down stakes
—
have been provided
to allow for almost endless configurations.
Soaker Dripline
1.
After determining what areas you wish to water, cut the Soaker Dripline into the
appropriate lengths*
2.
Insert a transfer barb into the end of one of the Soaker Dripline sections
3.
Punch a hole in the mainline tubing and insert the other end of the transfer barb into
the mainline
4.
Terminate the other end of the Soaker Dripline section with a goof plug (14GP2) and
stake down (SS3-10)
5.
Open the hose shutoff and test the system
Use the roll of blank ¼” tubing (non
-emitter) and transfer barbs to span non-watering areas
If you have any further questions about our products, or installing your drip system, please
contact us at 800-522-3747 or via email at [email protected] or visit our store at
DripWorks, 190 Sanhedrin Circle, Willits, CA 95490