www.petsafe.net 13
12 www.petsafe.net
EN
ES
FR
IT
NL
DE
.
Fountain Reassembly
1. Place the Foam Filter around the Pump and make
sure the electrical power cord rests on top
(
Fig. 20
).
2. Position the bowl so that the raised post should be
to the right of the square indention. Place the Pump
inside the square indention so the Pump outflow,
the circular opening on the top of the Pump, is
positioned in the bottom left corner of the
square (
Fig. 21
).
3. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed the
in-line plug of the electrical power cord over and
through the raised post and out the notch on the
base of the Bowl. (
Fig. 22
) There are four notches
to choose from.
4. Remove the extra slack from the electrical power
cord and insert the Rubber Cap into the raised
post. Make sure the cord channel on the Rubber
Cap is aligned with the electrical power cord, then
insert your finger into the Rubber Cap and push all
the way down.
5. Fold the top of the Rubber Cap over the raised post
to seal off the Bowl (
Fig. 23
).
6. Rinse a new Charcoal Filter thoroughly under cool
water before placing it into the Filter Housing. This
will remove any loose and excess charcoal dust,
which is harmless.
7. Detach the lid from the base of the Filter Housing.
Once rinsed off, place the Charcoal Filter inside
the base of the Filter Housing with the larger side
of the filter facing down. The filter will only fit inside
the base of the Filter Housing one way. If it does
not fit, flip it over.
8. Attach the lid to the base of the Filter Housing.
Press down until you hear it snap in place.
9. Attach the Filter Housing to the Pump by inserting
the round notch under the base into the circular
opening on top of the Pump. The opening on top of
the Filter Housing should be right next to the sealed
raised post (
Fig. 24
).
Electrical
power
cord rests
on top
Fig. 20
Fig. 21
Fig. 22
Fig. 23
Fig. 24
