www.petsafe.net 13
12 www.petsafe.net
EN
T-CN
S-CN
pet fountain Reassembly
1. Place the Foam Filter around the Pump. The rounded side of the Foam Filter should
be directly in front of the Faceplate on the Pump. Make sure the electrical power
cord runs over the top of the Foam Filter, not underneath it, as this will keep the
Foam Filter in place.
2. Replace the Pump into its original location (
fig. 2
). Be sure that the circular
opening on the top of the Pump is positioned in the Bowl’s true center or the
Intake Tube will not properly align with the Housing. Gently push down to engage
the suction cups.
3. Replace the Intake Tube into the circular opening on the top of the Pump (
fig. 3
).
4. Align the Cone so that the Power Cord runs through the Cord Notch while
keeping the Pump in its original position. Once the Power Cord is aligned
(
fig. 3
), gently place the Cone piece into resting position.
5. After cleaning your Pet Fountain, it is a good idea to replace your Filter with a
new one. After replacing the Charcoal Filter, screw on the Filter Housing Cap.
6. Look into the Cone opening and make sure the Intake Tube is sticking straight
up from the Pump. Carefully, insert the Filter Housing into the Cone opening and
push straight down. By pushing the Filter Housing all the way down to the rubber
gasket, the Housing should easily attach to the Intake Tube.
7. Choose your preferred Spout Ring (1 spout up to 5 spouts) and place on top of
the Filter Housing Cap, press it gently into place. Be sure it is pushed down evenly
all the way around.
8. Replace the Flow Control Cap by aligning the Flow Control Cap with the notches
on the Filter Housing Cap. Gently push down to secure in place.
9. Attach the three Cord Clips around the base of the Pet Fountain to hide the
electrical Power Cord and secure the Cone piece into place.
10. Fill the Pet Fountain Bowl with water. Make sure the water level is
at least
to the
minimum MIN (minimum) fill line so the Pump does not run dry. This will prime the
Pump for use. Do not fill the Pet Fountain past the MAX (maximum) fill line.
11. Place Pet Fountain in desired location. To properly pick up the Pet Fountain, use
both hands and grip underneath the sidewalls of the Bowl and lift.
Important:
Never pick up a full Pet Fountain by the center Cone piece! To take care of your
floors, we suggest to
always
use a protective mat or other durable, water
resistant surface. This will help protect your floor from any water that may splash
out from your pet’s use of the Pet Fountain.
12. Before plugging the Pet Fountain into electricity, make sure the Power Cord and
your hands are completely dry. Plug the Pet Fountain in to a standard wall outlet.
