SKU 93440
For technical questions, please call 1-800-444-3353.
Page 12
INSPECTION, MAINTENANCE, AND CLEANING
WARNING!
1.
Make sure the Trigger (19) of the Drill is in its “OFF” position, and
the Battery (27) is removed from the tool prior to performing any inspection,
maintenance, or cleaning procedures.
Before each use,
2.
inspect the general condition of the Drill and its Charger (30).
Check for loose screws, misalignment or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other condition that may affect safe
operation. If abnormal noise or vibration occurs, have the problem corrected before
further use.
Do not use damaged equipment
.
To clean the Drill,
3.
use only a clean cloth and mild detergent.
Do not use solvents. Do not immerse any part of the tool in liquids.
When storing,
4.
make sure to store the tool in a clean, dry, safe location out of reach
of children and other unauthorized people.
CAUTION! All maintenance, service, or repairs not mentioned in this man-
5.
ual must only be performed by a qualified service technician.
To Operate The Drill:
Select and install the desired drill or screwdriver bit.
1.
Make sure to install a fully charged Battery (27) in the Drill.
2.
(See Figure G.)
Set the Torque Selector located on the Gear Box (14) to the desired setting.
3.
(See Figures F and G.)
Squeeze (and hold) the Trigger (19) to turn on the Drill. The Trigger varies the
4.
speed of rotation depending on how far in it is squeezed.
(See Figure G.)
Avoid overloading the Drill. Always use sharp bits. Do not apply excessive
5.
pressure to the Drill while drilling. If the Drill speed drops abnormally, decrease
pressure immediately. If the bit stops abruptly, or the bit becomes stuck, release
the Trigger (19) at once.
(See Figure G.)
When driving screws into wood or plastics, drill a pilot hole first in the workpiece.
6.
Make sure the length and diameter of the hole is slightly
less
than that of the
actual screw. When driving screws into metal, drill a pilot hole slightly
more
than
that of the actual screw.
When finished using the Drill, always remove the Battery (27). Then remove
7.
the drill or screwdriver bit and store the tool in a clean, dry, safe location out of
reach of children and other unauthorized people.
