Page 9
SKU 91396
for technical questions, please call 1-800-444-3353.
asseMBlY and operating instructions
note:
For additional information regarding the parts mentioned in the following pages,
refer to the
assembly diagrams on pages 15 and 16.
charging:
note:
The Battery (11A) requires charging. The first charge requires
7 hours
charge
time prior to using the Drill or Flashlight.
The Battery (11A) should only be recharged when the Drill begins to run slowly or
1.
the Flashlight Bulb begins to dim.
When the Battery (11A) requires recharging, a
2.
5 to 7 hour
charge allows the tool
to operate at full power.
note:
Typically, a rechargeable Battery must be used
and recharged several times over before it begins to eventually operate at full
power when it is recharged thereafter.
caution!
3.
Do not recharge the Battery longer than 7 hours, as damage to the
Battery and/or Drill or Flashlight will occur.
figure d
2-prong plug
ac/dc adapter
(25a)
BatterY
(11a)
BatterY charger
(24a)
cord
4.
To charge the Battery (11A), insert the Battery’s
Plug
into the
Charging Socket
of the Battery Charger (24A). Next, plug the AC/DC Adapter (25A)
Cord
into the
Battery Charger. Then, plug the AC/DC Adapter
2-Prong Plug
into the nearest
120 volt, grounded, electrical outlet.
(see figure d.)
A
5.
Charging Indicator Light
on the Battery Charger (24A) will illuminate to
show that charging is taking place.
note:
The Battery Charger (24A) will
not
automatically turn off when the Battery (11A) is fully charged, and the Charging
Indicator Light will remain on until the Battery Charger is disconnected from the
electrical outlet. Recharging the Battery more than 7 hours can cause damage to
the Battery cells.
(see figure d.)
