Page 7
For technical questions, please call 1-800-444-3353.
Item 69438
Operating instructions
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pRevent SeRiOuS injuRY FROm aCCiDental OpeRatiOn:
Release the pressure and unplug the tool from its electrical outlet before
assembling or making any adjustments to the tool.
tO pRevent SeRiOuS injuRY:
DO nOt OpeRate With anY GuaRD DiSaBleD, DamaGeD, OR RemOveD.
installing the Wheel
1. The Grinding Wheel MUST be:
• rated to at least 5000 RPM.
• no larger than 6" in diameter.
• fitted with a 5/8" round arbor hole.
• suitable for edge grinding, not surface grinding.
• dry and clean.
• proven undamaged by inspection and
by the ring-test explained below.
2. Closely inspect the Grinding Wheel before mounting.
Perform a ring-test on the wheel
(unless wheel is smaller than 4″) as follows:
a. Suspend wheel using a dowel or
finger through the arbor hole.
b.
tap
Wheel
here
45°
45°
45°
45°
hang
Wheel
from
Dowel
v
e
R
t
i
C
a
l
C
e
n
t
e
R
Tap the flat side of the wheel with a light non-
metallic object, such as a screwdriver handle,
at a point 45° from the vertical center line on
each side of the wheel and 1 – 2 inches from
the edge of the wheel (see Illustration).
c. Rotate the wheel 90° and repeat the test
until the entire wheel has been checked.
d. An undamaged wheel will give a clear tone.
If cracked, there will be a dead sound
and not a clear ring.
3. Release the Safety Chain and guide the
Housing to rest at its full upward position.
4.
Moveable Guard
Nut
Swing open
Figure B
Loosen the Knob on the Moveable Guard and
swing it open, exposing the Blade and Flange.
5. Using the included wrenches, hold the Spindle
in place with the flat Wrench and loosen
the Outer Flange with the Pin Wrench.
6. Remove the Outer Flange and Blade,
noting the orientation of each.
7. For wheels with paper gaskets (blotters) or
metal gaskets: Slip the grinding wheel onto the
Spindle with the gasket first. The gasket should be
centered on the grinding wheel and the wheel and
gasket should rest flat against the Inner Flange.
WaRninG: to prevent serious
injury, gaskets must be used for all
grinding wheels they are provided with.
Gaskets help prevent grinding wheel damage
and wheel slippage, causes of wheel failure.
8. Thread the Outer Flange onto the Spindle
and tighten in place with the Wrenches.
9. Swing the Moveable Guard back in
place and tighten the Knob.
10. Lower the Housing and replace the Safety Chain.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup
