A
WARNING
ELECTRIC SHOCK HAZARD
Keep motor and electrical parts
dry.
Do not operate in standing water
Do not expose to rain, water or
snow.
Do not get the exterior. motor or wir-
ing wet.
Do not dean with wet objects, i.e.,
power washers, soap and water, etc.
If motor or electrical parts become
wet, allow them to dry completely
before using.
Read and understand manual be-
fore operating
a
WARNING
FIRE HAZARD
Keep air intakes clear. Reduced
airflow can cause motor to overheat.
Clean any lint or other material
from the screens before each use
Do not operate near draperies or
other material that could block the
air intakes.
Clean dust and dirt from motor
using a vacuum or compressed air.
Do not use or store where flamma-
ble vapors like gasoline, solvents, or
thinners are present.
Do not use near open flames, or
heat sources.
Read and understand manual be-
fore operating.
READ AND SAVE THESE INSTRUCTIONS
07-01537 Copyiight 2006 Dri-Eaz Products, Inc.
COOL AND VENTILATE
Place the airmover on a flat surface, and direct the air from cooler
areas (including the outdoors) into a warm room.
TURBODRYER STORAGE
Stackable
Units can be stacked (up to 3) on their sides
for storage.
NOTICE
Stacking feature is not secure enough to
be used during transport.
I A
WARNINO
N
ea
l
I
Always disconnect the TurboDryer from its
power source
before
performing any mainte-
nance or cleaning.
Preventive Maintenance
Routine maintenance can significantly increase the life of your Tur-
boDryer ft also promotes efficient operation. The applications and
amount of use by owners vary, so the recommendations listed below
are for average-to-high-volume use in water damage. Constant opera-
tion or use in other environments
may
require additional maintenance.
Contact Dri-Eaz for more information.
NOTE: Do not oil motor bearings: they are permanently oiled.
BEFORE EACH USE:
•
Inspect power cord for cuts, fraying or damage; do not use if dam-
aged
•
Remove lint or obstructions from the grills using a vacuum or com-
pressed air
•
Inspect exterior components (switch, knob, etc ) for damage.
QUARTERLY (OR AS NEEDED):
•
Clean the exterior with a household all-purpose spray cleaner.
Spray the rag. then apply to the surface.
•
To renew shine on the plastic. use a vinyl cleaner.
•
Remove grill and blower, then blow off internal components with
compressed air.
ANNUALLY:
•
Inspect
components and internal Wring for discoloration, loose
con-
nections, or fraying.