Dri-Eaz Sahara ProX3 115V Скачать руководство пользователя страница 2

C

OOL

 

AND

 V

ENTILATE

 

Place the airmover on a flat surface, and direct the air from cooler 
areas (including the outdoors) into a warm room.

 

T

URBO

D

RYER

 S

TORAGE

 

 
 

 
 
 
 
 
 
 

 
 

READ AND SAVE THESE INSTRUCTIONS 

Stackable

 

Units can be stacked (up to 3) on their sides 
for storage.  
 

NOTICE 

Stacking feature is not secure enough to 
be used during transport.

 

 2 

Preventive Maintenance

 

Routine maintenance can significantly increase the life of your Tur-
boDryer. It also promotes efficient operation. The applications and 
amount of use by owners vary, so the recommendations listed below 
are for average-to-high-volume use in water damage. Constant opera-
tion or use in other environments may require additional maintenance. 
Contact Dri-Eaz for more information.  
NOTE: Do not oil motor bearings; they are permanently oiled. 

 

B

EFORE

 E

ACH

 U

SE



Inspect power cord for cuts, fraying or damage; do not use if dam-
aged. 



Remove lint or obstructions from the grills using a vacuum or com-
pressed air. 



Inspect exterior components (switch, knob, etc.) for damage. 

Q

UARTERLY

 (

OR

 

AS

 

NEEDED

): 



Clean the exterior with a household all-purpose spray cleaner. 
Spray the rag, then apply to the surface.

 



To renew shine on the plastic, use a vinyl cleaner. 



Remove grill and blower, then blow off internal components with 
compressed air. 

A

NNUALLY



Inspect components and internal wiring for discoloration, loose con-
nections, or fraying.  

 

 

WARNING

  

ELECTRIC SHOCK HAZARD

  

Keep motor and electrical parts 
dry. 

Do not operate in standing water. 
Do not expose to rain, water or 
snow. 
Do not get the exterior, motor or wir-
ing wet. 
Do not clean with wet objects, i.e., 
power washers, soap and water, etc.  
If motor or electrical parts become 
wet, allow them to dry completely 
before using. 

Read and understand manual be-
fore operating

.

 

 

Always disconnect the TurboDryer from its 
power source before performing any mainte-
nance or cleaning. 

WARNING 

 

WARNING

 

 
Keep air intakes clear. 

Reduced 

airflow can cause motor to overheat. 
Clean any lint or other material  
from the screens before each use. 
Do not operate near draperies or 
other material that could block the 
air intakes. 
Clean dust and dirt from motor  
using a vacuum or compressed air. 
Do not use or store where flamma-
ble vapors like gasoline, solvents, or 
thinners are present. 
Do not use near open flames, or 
heat sources. 

Read and understand manual be-
fore operating

.

 

 

FIRE HAZARD

 

07-01537C  2013-01  Warranty 07-00419 

Dri-Eaz Products, Inc. 

Содержание Sahara ProX3 115V













Отзывы: