07-01899G F413-230V EU/UK
3
Legend Brands Holdings Ltd.
User Settings Menu
A number of display settings may be changed by the
user. System information can also be displayed. These
items are accessed by pressing
DISPLAY MENU.
Each press of the key will display the next parameter.
When you reach the parameter you wish to adjust, press
MENU SELECTION to increase the value. Press
DISPLAY MENU again to accept the setting and re-start
the display cycle.
Note that only menu items followed by a greater-than
symbol (
>
) may be adjusted.
All settings and modes are discussed in detail in Control
Panel Guide.
Error messages
If the onboard diagnostics discover a problem, the unit
will display an error message. See “Error Messages,”
below, for an explanation of each message.
Control Panel Guide
ON/OFF
.
Press to turn the unit on or off. When the ma-
chine is turned on, the display normally reads PLEASE
WAIT COMP. DELAY and performs a numeral count-
down for a maximum of 60 seconds to 0. This delay al-
lows time for refrigerant pressures to equalize for easier
starting. Once the unit completes the compressor delay,
the display shows UNIT ON XX HRS and cycles be-
tween INLET XX°F and INLET XX%. NOTE: If no com-
pressor delay countdown is displayed, a delay is not
necessary and the machine will begin operation immedi-
ately.
DISPLAY MENU.
Press to cycle through the display of
additional dehumidifier conditions and User Settings. To
return to the main menu, press the ON/OFF key once.
MENU SELECTION.
Press to change the values of the
"User Defined" settings. The MENU SELECTION key
acts as the UP key for adjusting the setpoint for Humidi-
stat mode operation. See User Settings Menu (below)
for details.
PURGE.
Press to empty water from the condensate
pump reservoir. The display will read PUMP PURGING
with a numeral countdown.
NOTE: During normal operation, the pump purges auto-
matically.
Changing settings and viewing system information
Display setting changes and system information can be
accessed by pressing
DISPLAY MENU. Each press
of the key will display the next parameter (see list be-
low). When you reach the parameter you wish to adjust,
press
MENU SELECTION to increase the value.
Press
DISPLAY MENU again to accept the setting
and re-start the display cycle
Note that only menu items followed by a greater-than
symbol (
>
) may be adjusted.
ON/OFF
Press and release to turn unit
on
or off.
DISPLAY MENU
Press to select next item in
menu. Menu item will show in
display.
MENU SELECTION /
UP KEY
Press to toggle or select values
in menu displayed.
PURGE PUMP
Press and release to start purge.
Display will count down sec-
onds remaining until purge is
complete.
CONTROL PANEL
ON/OFF
DISPLAY
DISPLAY
MENU
MENU
SELECTION /
UP KEY
PURGE PUMP
