DRESSTA 32501, Руководство оператора

Страница: 25 / 177

SECTION 2
SAFETY PRECAUTIONS
Page 8
TD-15H DRESSTA
OPERATION
Never shift the transmission into neutral (N) when traveling downhill. The machine may go out of
control and a rollover could result or the transmission, torque converter or engine could be
damaged when the transmission is again placed in gear. Always put the transmission in low range
position before starting downhill. Use the decelerator and brake pedal to slow the machine.
Avoid side hill travel whenever possible. Drive straight up and down the slope. If the machine
starts slipping sideways on a grade, turn downhill immediately.
If possible avoid crossing obstacles such as ridges, rocks or logs. If you can't avoid them, reduce
speed and ease over the obstacle at an angle.
Machine's weight and the vibration it creates can cause the edge of a high wall to collapse. Keep
your machine back from the edges of banks and excavations. If it cannot be avoided drive the
machine at the straight angle to the edge.
Travel slowly in congested areas or on rough ground, slopes or near drop-offs or on snow, ice or
slippery surfaces.
Maintain a safe distance between your machine and other vehicles according to the condition of
the road and load.
Never hold the hydraulic controls in their extreme position after the equipment has reached its
maximum travel. This could cause overheating of the hydraulic system.
Do not adjust the seat position while the machine is in motion. A loss of control may result.
Completely stop the machine, apply and lock the parking brake and then adjust the seat.
Never use the blade as a brake except in an emergency.
Carry the blade low for maximum stability and visibility.
Where noise exposure exceeds the levels defined by proper health and safety authorities and
applicable standards wear authorized ear protective equipment.
2.4. MAINTENANCE
Authorized personnel only is allowed to maintain or repair a machine. It is forbidden to allow any
unauthorized person to control the machine.
Do not hasten. It may cause accidents.
Put objects onto a machine standing on the ground level before you climb on the machine.
Loosen the radiator cap slowly to relieve all pressure in the system and use caution when
removing the cap to prevent possible injury.
Have all equipment resting on the ground or blocked before removing any hydraulic component.
Actuate the control levers in opposite directions to relieve all pressure from the system.
Never work beneath a blade or ripper without proper blocking. Improper blocking could result in
serious injuries.
https://www.truck-manuals.net/