User Manual
Version 1.4
2017-04-25
RaspBee ZigBee addon board
Page 9 of 22
4.2.1. Hardware
•
Raspberry Pi (type B ), RPi2 or RPi3
•
Recommended Power supply for Raspberry Pi, RPi2 or RPi3
(AC/DC to Micro-USB, 5.0 V DC, min. 2 A)
•
SD card / MicroSD card for OS and software
4.2.2. Software
•
Linux operating system (Raspbian Linux distribution
1
)
•
deCONZ for ARMv6 Linux
2
•
ZigBee firmware for RaspBee
3
(optionally)
4.3.
Setup the components and start the application
1. Unpack the RaspBee unit.
2. Please make sure that the Pi is switched off.
3. Connect the RaspBee to the RPi’s user header. Pin 1 of RaspBee (square marker) must
be connected to Pin 2 of RPi header P1 at the board edge. Use the same header position
for RPi2 or RPi3.
Figure 3: RPi user header
Notes:
Double check that the header is
NOT
shifted inadvertently since this may
damage the RaspBee board irreversible.
Do not connect the RaspBee if the RPi is powered since this will cause a
restart of the host device.
4. Power-On the RPi and wait until the login prompt is available.
5. Log in and acquire superuser rights.
1
Refer to http://www.raspbian.org/
for download and installation instructions
2
deCONZ is available in the download area on http://www.dresden-elektronik.de
3
ZigBee firmware is available in the download area on http://www.dresden-elektronik.de. (section
deCONZ, file extension
.bin.GCF
).
PDF wurde mit pdfFactory Pro-Prüfversion erstellt.
