The number and variety of accessories for the
Rotary Tool are almost limitless. There is a
category suited to almost any job you might
have to do — and a variety of sizes and shapes
within each category which enables you to get
the perfect accessory for every need.
Refer to the DREMEL ACCESSORY ORDER
FORM for illustrations of the accessories
available. These accessories may be found
at your local hardware, hobby or home
center dealers.
Collets
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets. Store
these so that you will have the proper size of
collet for any accessory or drill bit you want to
use.
Currently, the 3,2 mm, 2,4 mm, 1,6 mm
and 0,8 mm collets accommodate all of the
available Dremel accessories. 3,2 mm
collets are included in most rotary tool kits.
-14-
Maintenance
Service
NO USER SERVICEABLE
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard.
We recommend
that all tool service be performed by a Dremel
Service Center. SERVICEMEN: Disconnect
tool and/or charger from power source before
servicing.
D.C. motors
The motor in your tool has been engineered for
many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Dremel replacement motor
specially designed for your tool should be used.
Cleaning
To avoid accidents, always
disconnect the tool and/or
charger from the power supply before
cleaning.
The tool may be cleaned most
effectively with compressed dry air.
Always
wear safety goggles when cleaning tools
with compressed air.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through opening.
Certain cleaning agents and
solvents damage plastic
parts.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that
contain ammonia.
!
WARNING
!
WARNING
!
CAUTION
Extension Cords
If an extension cord is
necessary, a cord with
adequate size conductors that is capable of
carrying the current necessary for your tool
must be used.
This will prevent excessive
voltage drop, loss of power or overheating.
Grounded tools must use 3-wire extension
cords that have 3-prong plugs and receptacles
RECOMMENDED SIZES OF EXTENSION CORDS
240 VOLT ALTERNATING CURRENT TOOLS
!
WARNING
Dremel Accessories
Use only Dremel™, high-performance accessories.
Other accessories are
not designed for this tool and may lead to personal injury or property damage.
!
WARNING
Max. Tool
Ampere Rating
Cord Ampere
Rating
Cord Sizes in
mm
2
10
10
1,0
25
10
15
1,5
32
Cord Length
in Meters
DM 2610945859 05-07 7/10/07 8:43 AM Page 14
