© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
9
MYSTERIE shower door manual Ver 6 Rev 7 07/2018
©2018 DreamLine. All Rights Reserved
Fig 3
Fig 4
Door end of guide rail
High spot of disk bushing
EQ
EQ
measure
glass bracket
disk
TIP:
Mark the location of the high spot on the outer surface of the
adjustment disk with a felt tip pen to make adjustment easier to see.
2
stopper hole
1
panel end
stationary
panel-end
3
thread lock
door-end
4
outside
5
6
outside
outside
outside
3a.
Attach the
Upper Guide Rail (#03)
to the
Stationary Glass (#02)
with the
Glass Brackets (#07)
and tighten the bolts into the holes in
the
Upper Guide Rail (#03)
. Make sure both adjustment disks are
installed in the same direction with the high spot towards the door
end. (see
*
Note below)
Make sure that the guide rail is attached parallel with the top edge of
the stationary panel glass.
*NOTE:
The outer glass bracket disk has an eccentric bushing
for adjustment. Be sure to install both glass bracket disks with
the high spot of the bushing pointed towards the door end of
the guide rail.
3b.
Slide the
Door Stoppers (#01)
onto each end of the
Upper
Guide Rail (#03).
Secure them using the
4mm Allen Wrench (#11).
Install the panel-end stopper into the pre-drilled stopper hole in
the Upper Guide Rail and apply thread lock to the set screw.
(Fig 3.3)
Install the door-end stopper approximately 4” from the end
of the guide rail. (The door-end stopper position will be adjusted
after the door glass is installed).
3c.
Slide the
Guide Rail Brackets (#08)
onto each end of the
Upper Guide Rail (#03)
and secure them. Next, assemble the
Wall Bracket (#19)
onto the bottom corner of the
Stationary
Glass (#02)
with the bolt facing the inside of the shower as shown
in
Fig 3.5.
Use the supplied gaskets to protect the glass.
(Fig. 3 and Fig. 4)
