16
17
EN
EN
Clean the Main Brush
Clean the Side Brush
Clean the Main Wheel / Omnidirectional Wheel
Routine Maintenance
Press the brush guard clips inwards to remove the brush guard and
lift the brush out of the robot.
Pull out the side brushes and use the included cleaning tool to
remove any hair tangled on the brush.
Pull out the brush cover as shown in the diagram. Use the included
cleaning tool to remove any hairs tangled in the brush.
Note:
Do not pull out the hair excessively to avoid damaging the main brush
when the hair is tightly tangled in the main brush.
Note:
Use a tool such as a small screwdriver to separate the axle and the tire.
Clean the LDS Laser Sensor/Edge Sensor
Clean the Charging Contact
Clean the High Precision 3D
Clean the Cliff Sensor
Routine Maintenance
Note:
Wet cloths can damage sensitive elements within the robot and charging dock. Please use dry rags for cleaning.
If the robot stops responding or cannot be turned off, press and hold down the button for 10
seconds to forcefully turn it off. Then press and hold the button for 3 seconds to turn the robot
on.
The robot contains a high-performance lithium-ion battery pack. Please ensure that it remains
well-charged for daily use to maintain optimal battery performance. If the robot is not used for an
extended period of time, turn it off and put it away. To prevent damage from over-discharging, the
robot should be recharged at least once every three months.
Robot Restarting
Battery
