6 of 73
Reference Manual ATOM one 4K mini
2 General Operation
For regular operation the camera needs only a power supply. For controlling and updating
the camera a RS485 connection is required.
This can be done with the given RS485 USB converter. Connect the USB connector to
your PC and let the operation system install the required drivers.
For RS485 an address is required to access the camera. The default address is “1”.
After powering up the camera the camera will boot. The boot process takes ~3 seconds.
2.1 Connectors
The ATOM one 4K has two 6 pin Hirose HR10 connectors.
1. Power: Male HR10 6 pin
2. AUX: Female HR10 6 pin
2.1.1
Power and RS485 Connector
The power connector is male and will mate with a female hirose HR10A-7P-6S(73) .
Note: The pin order of HR10A of male and female is counted in different directions.
The following table shows the numbering and cable colors of used Dream Chip adapters.
Female
HR10A-7P-6S(73)
Signal
Cable
6 wire
Cable
4 wire
USB RS485
6
Power in
6-36 Volt
Red
Red
-
5
GND
Brown
Brown
Black (gnd)
4
RS485_TX_P
Black
Looped to pin 1
3
RS485_TX_N
Green
Looped to pin 2
2
RS485_RX_N
Yellow
Black
Yellow (D-)
1
RS485_RX_P
Orange
Orange
Orange (D+)
2.1.2
AUX Connector
The axillary connector is female and will mate with a male hirose HR10A-7P-6P(73).
Note: The pin order of HR10A of male and female is counted in different directions.
