Draytek Vigor 2930, Руководство пользователя

Страница: 114 / 216

Vigor2930 Series User’s Guide 108
Callback Budget (Unit: minutes)- Specify the time budget
for the dial-in user. The budget will be decreased
automatically per callback connection. The default value 0
means no limitation of callback period.
My WAN IP This field is only applicable when you select ISDN, PPTP or
L2TP with or without IPSec policy above. The default value is
0.0.0.0, which means the Vigor router will get a PPP IP
address from the remote router during the IPCP negotiation
phase. If the PPP IP address is fixed by remote side, specify
the fixed IP address here. Do not change the default value if
you do not select ISDN, PPTP or L2TP.
Remote Gateway IP This field is only applicable when you select ISDN, PPTP or
L2TP with or without IPSec policy above. The default value is
0.0.0.0, which means the Vigor router will get a remote
Gateway PPP IP address from the remote router during the
IPCP negotiation phase. If the PPP IP address is fixed by
remote side, specify the fixed IP address here. Do not change
the default value if you do not select ISDN, PPTP or L2TP.
Remote Network IP/
Remote Network Mask Add a static route to direct all traffic destined to this Remote
Network IP Address/Remote Network Mask through the VPN
connection. For IPSec, this is the destination clients IDs of
phase 2 quick mode.
More Add a static route to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
RIP Direction The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction
here. Herein, we provide four options: TX/RX Both, TX Only,
RX Only, and Disable.
From first subnet to
remote network, you
have to do
If the remote network only allows you to dial in with single
IP, please choose
NAT , otherwise choose Route .
Change default route to
this VPN tunnel Check this box to change the default route with this VPN
tunnel. Be aware that this setting is available only for one
WAN interface is enabled. It is not available when both WAN
interfaces are enabled. You have to disable one WAN