Please Note:
Screen limits are factory set. Instructions below for
minor adjustments only. Please check with Draper prior to resetting
screen limits.
Please Note:
If Access XL E/V is “Right Hand Motor,” the WHITE/DOWN
(I)
and YELLOW/UP
(II)
limit screws are reversed
(Fig. 9)
.
Section 8 -
Limit Adjustments
Section 8.1 - Limit Adjustments
Section 8.1.1 - "Down" Limit Adjustment
(requires a
5
/
32
" (4 mm) Allen wrench)
To Reduce Screen Drop:
1.
Raise screen surface approximately
1'
(30 cm)
above desired setting and
turn off.
2.
Turn DOWN
(I)
limit screw clockwise
(3 screw turns =
1
/
2
roller revolution)
.
3.
Test by lowering screen. Repeat
steps 1 & 2 until desired position is
reached.
To Increase Screen Drop:
1.
Lower screen to down limit.
2.
With down switch on, turn DOWN
(I)
limit
screw counterclockwise
(3 screw turns =
1
/
2
roller revolution)
to increase drop.
3.
Test by raising screen approximately
1'
(30 cm)
then down to new down limit.
4.
Repeat steps 2 and 3 until desired
position reached.
Caution:
- Be sure all switches are in “off” position before adjusting limit switches.
- Be prepared to shut off manually while testing.
- Screen may be damaged by lowering it too far and exposing roller.
- Motor must be installed so limit switches are pointed down.
Section 8.1.2 - "Up" Limit Adjustment
If Screen Raises Too High:
1.
Lower screen surface approx.
1'
(30 cm)
below desired setting
and turn off.
2.
Turn UP
(II)
limit screw clockwise
(3 screw turns =
1
/
2
roller
revolution).
3.
Test by advancing screen up.
4.
Repeat steps 1 through 3 until
desired position is reached.
If Screen Needs to Raise Higher:
1.
Lower screen surface
approx. 1'
(30 cm)
below desired setting
and turn off.
2.
With Up switch on,
turn UP
(II)
limit screw
counterclockwise
(3 screw turns =
1
/
2
roller revolution)
.
3.
Repeat steps 1 and 2
until desired position
is reached.
Caution:
DO NOT allow dowel to wrap over roller when operating screen! This could damage screen.
Figure 9
Left hand motor:
White Socket—Down
Yellow Socket—Up
Right hand motor:
White Socket—Up
Yellow Socket—Down
Left hand motor:
White Socket—Up
Yellow Socket—Down
Right hand motor:
White Socket—Down
Yellow Socket—Up
Left hand motor:
White Socket—Down
Yellow Socket—Up
Right hand motor:
White Socket—Up
Yellow Socket—Down
Waterfall Roll
Standard Roll
Motor
End
Audience
Side
Motor
End
Audience
Side
Reverse Roll
Motor
End
Back
Side
Ultimate Access XL E & V
Electric Projection Screen
page 5 of 7
