Section 1 -
Mounting
Caution:
Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note:
Installer is responsible for selecting mounting hardware appropriate for site conditions.
1.
Open carton along length, not at end. DO NOT use a knife to open.
2.
Each shade is tagged with the size. If fascia is included, each piece is marked.
3.
Install all Draper window shades level. Check with carpenter’s level.
4.
Left and right brackets are different; be sure you are installing the proper brackets in the proper opening.
Please read the following installation guidelines thoroughly and follow them carefully. Failure to do so may cause product to fall or otherwise fail, and
invalidates warranty.
Caution:
Before mounting shades, verify measurements on the card provided with the shade, and ensure the brackets are installed at the correct width.
Section 1.1 - Mounting with Brackets
1.
Mount brackets according to type of installation. Use appropriate fasteners
(two per bracket)
for wall, jamb or ceiling
(see Fig. 1)
. The installer is responsible
for selecting mounting hardware appropriate for site conditions.
2.
Insert idler end into right bracket
(see Fig. 2)
.
3.
Lower spear on left end of roller into left bracket and rotate into locked
position
(see Fig. 3)
. Note: The notch on the spring roller should be positioned
down. The spring has been pre-tensioned in the factory.
Section 1.2 - Mounting with Endcaps
1.
For installations with fascia, mount endcaps according to type of installation.
Use appropriate fasteners for wall, jamb, or ceiling
(see Fig. 4)
.
The installer is responsible for selecting mounting hardware appropriate
for site conditions. Snap end covers onto endcaps.
2.
Insert idler end into right endcap.
3.
Lower spear onto left endcap and rotate into locked position.
4.
Place fascia top lip over top edge of endcaps, then rotate down and snap
into place
(see Fig. 5)
. NOTE: Make sure shade fabric does not retract
completely behind fascia.
Caution:
Fascia is not fully seated until it clicks into place on both ends.
Once in place, check for secure fit. If not secure, secure with appropriate
fastener
(not included)
.
Please Note:
Small hardware shown. Large hardware will look slightly different,
but install and operate the same way.
WITH BRACKET MOUNT
WITH ENDCAP MOUNT
STEP 2
Clicks into place
STEP 1
STEP 2
Clicks into place
STEP 1
Figure 1
Figure 4
Figure 5
Figure 2
Figure 3
For wall mounting, place pin in this hole
For wall mounting, place pin in this hole
Square Fascia
Radius Fascia
For ceilingl mounting, place pin
in this hole
For ceilingl mounting, place pin
in this hole
page 3 of 4
Spring Roller Shade
