Draper PT142K, Руководство пользователя, Страница: 7 / 18

5.2 ADDITIONAL SAFETY INSTRUCTIONS
- Wear ear protectors with impact drills. Exposure to noise can cause hearing loss.
- Use auxiliary handles supplied with the tool. Loss of control can cause personal injury.
- Wear eye protection.
- Wear dust mask.
5.3 CONNECTION TO THE POWER SUPPLY
Make sure the power supply information on the machine’s rating plate are compatible
with the power supply you intend to connect it to.
This drill comes supplied with a UK standard 3 pin plug fitted. It is designed for connection
to a domestic power supply rated at 230V AC.
It is a Class 2 machine (double insulated); is designed for connection to a power supply
matching that detailed on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this
appliance. Follow all the instruction supplied with the extension lead.
This product requires no earth connection as supplementary insulation is applied to the
basic insulation to protect against electric shock in the event of failure of the basic
insulation.
Apart from replacing the fuse in the plug, no other electrical work is recommended on this
drill.
10
5. HEALTH & SAFETY INFORMATION
7A
9. BASIC MULTI-TOOL OPERATIONS
8.4 APPLICATIONS:
Your multi-tool can be used for drilling, grinding,
polishing, milling and brushing. Other jobs like
engraving, cutting and removing rust are also possible. It
can be used on most wood, metal, glass and ceramics.
It is a good idea to practice on a scrap piece of material.
Best results are achieved by an even speed and pressure
(not too hard). Use lower speeds for larger tools and
higher speeds for smaller tools.
WARNING: Excessive force on this machine will cause
the motor to overheat and fail. This is not covered by
the guarantee.
8.5 HOLDING THE TOOL - FIGS. 5 - 6
For jobs such as milling or engraving where precision is
required, hold the multi-tool like a pen.
Care should be taken not to fully cover exhaust vents.
Covering the vents will cause the machine to overheat
and fail.
For heavier work like cutting or grinding hold the
multi-tool in the palm of your hand.
8.5 FITTING A CUTTING/SANDING DISC - FIG. 7
With the disc holder in the chuck, remove the screw
using the plain slot screwdriver (incorporated in the
spanner handle tip). Remove one of the spacing washers
from the end. Insert the screw through the cutting disc,
the washer and secure into the holder (Do not over
tighten).
8.6 FITTING THE SANDING DRUMS - FIG. 8
To fit a drum , firstly loosen the small screw in the
top of the holder . This will allow the rubber to
relax. Slide the sanding drum onto the holder. To secure
simply tighten the screw and the rubber drum will swell,
gripping the drum. (Do not over tighten).
FIG.7
FIG.8
FIG.5
FIG.6