5.1 GENERAL SAFETY INSTRUCTIONS
Read all safety warnings and instructions.
Failure to heed these markings may result in
personal injury and/or property damage.
Save all warnings and instructions for future reference.
The warnings, precautions and instructions discussed in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by
the operator.
5.2 REDUCING RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Do not disassemble. Do not attempt repairs or modifications.
Refer to qualified service agencies for all service and repairs.
Do not use this product in or area where it can fall or be pulled into water or other liquids.
Do not reach for this product if it has fallen into liquid.
Use this compressor with 12-volt DC systems only.
This product should never be left unattended during use.
5.3 PREVENTING INJURY
Never allow children to operate this compressor.
Close supervision is necessary when this compressor is being used near children.
This compressor will become HOT during and immediately after use.
Do not touch any part of this compressor with bare hands, other than the ON/OFF switch during
and immediately after use.
Do not use this product near flames or explosive materials or where aerosol products are
being used.
Do not operate this product where oxygen is being administered.
Do not pump anything other than atmospheric air.
Never use this product while sleepy or drowsy.
Do not use any tools or attachments without first determining maximum air pressure for that tool
or attachment.
Never point any air nozzle or air sprayer toward another person or any part of the body.
This air compressor is equipped with an Automatic Reset Thermal Protector, and can automatically
restart after the thermal protector resets. Always cut off power source when thermal protector
becomes activated.
Wear safety glasses or goggles when operating this product.
Use only in well ventilated areas.
After usage, always release excess pressure from the coil hose by turning On/Off switch to the Off
position, disconnect hose from compressor, with the tyre inflation gun still connected to the other
end of the coil hose, pull trigger on the tyre inflation gun to release excess pressure.
5. HEALTH AND SAFETY INFORMATION
- 6 -