9. SETTING THE WATER PUMP
9.1 PREPARING THE PUMP - FIGS. 4 - 7
It is important to check the pump before you
commence operating the unit.
IMPORTANT: Ensure that the engine has oil. When
leaving the factory, this water pump has NO OIL in the
engine.
NOTE: The water pump has a low oil sensor and will
not start if it has no oil (Fig.1).
9.2 FUELLING
Use unleaded petrol only.
1. Remove the petrol cap
.
2. Ensure the fuel filter is in place - Do not pour fuel
into the tank without the fuel filter
in place.
3. Do not over fill - leave air gap at top of fuel level.
4. Always screw down fuel cap.
5. Clean up any spilled fuel immediately.
6. Move water pump at least 12 feet (4M) away from
the fuelling area before starting.
WARNING:
• Do not refill fuel tank while engine is running or is
hot.
• Check to ensure that the petrol cap has been
tightened and that fuel is not leaking.
• Be careful not to admit dust, dirt, water or other
foreign objects into the fuel.
• Wipe off spilt fuel thoroughly before starting
engine.
• Ensure you DO NOT fuel the pump in close
proximity to any open flames.
FIG.4
FIG.5
FIG.6
FIG.7
11
