Draper 65121, Инструкция по эксплуатации

Страница: 8 / 12

OPERATION & USE
BATTERY CHARGING
To charge the battery pack it must first be removed
from the drill. To release the battery pack squeeze
the grips located on either side of the battery
casing and gently pull the battery pack from the
housing (fig.1). Connect the charger plug to the
charging base and insert the battery into the
charging base (fig.2). Plug the charger plug into a
suitable 13Amp three pin socket. The green light
indicator will illuminate to show power at the
charger and the red light will illuminate indicting
that charging is taking place. During charging the
battery may become warm to the touch - this is
normal. The battery charge time is approx. 3-5
hours, after which the battery should be removed.
The battery pack can then be removed and used to
power the tool. To refit the battery pack to the drill
push firmly until the battery pack locates and snaps
into place.
NOTE:
The charger WILL NOT automatically switch off
when the battery is fully charged and the red
charge indicator will remain on. Switch off when
fully charged. DO NOT EXCEED 6 HOURS,
OTHERWISE THE BATTERY MAY BE DAMAGED.
NOTE:
The battery was discharged after manufacturing
and will therefore require five to ten
charges/discharges before it reaches its full
capacity.
INSTALLING AND REMOVING BITS
This drill is fitted with a keyless chuck, this means
that a chuck key is not required to secure the drill
or screwdriver bit. Place the drill bit into the chuck
as far as it will go, then hand tighten.
Short screwdriver bits need only be inserted to the
depth of the hexagon shank before tightening the
chuck by hand. Alternatively grip part
✪✌
of the
chuck, (fig.4) and slowly run the drill clockwise
until the chuck grips the bit, then hand tighten.
DIRECTION SWITCH
This switch determines the direction of rotation of
the chuck, i.e. clockwise or anticlockwise.
To alter the direction of rotation, stop the drill and
push
✮✌
, (fig.5), switch to the left or right. When
the direction switch is in the ‘forward’ position the
chuck will rotate clockwise when viewed from the
handle end of the drill. When the switch is in the
‘reverse’ position the chuck will rotate
anticlockwise when viewed from the handle. Before
operation check that the switch is set in the required
position. Do not change the direction of rotation
until the chuck comes to a complete stop.
When the drill is not in use move the direction
switch to the neutral position (the middle setting).
- 7 -
Fig.1.
Fig.2.
Fig.5.
Fig.6.
Fig.4.
✪✌
✮✌
Fig.3.
FORWARD
REVERSE