8. PREPARING THE HEATER
8.1 HANDLE FITMENT (32286 & 32287) - FIG. 1
i. Align the holes in the upper housing with the two
mounting holes on the handle.
ii. Screw the handle securely with the screws provided.
8.2 HANDLE & WHEEL FITMENT (32285 & 53926) -
FIGS. 2 - 3
i. Slide the axle
through the leg frame
.
ii. Push the wheels
onto the axle
. The protruding
hub goes on the inside.
iii. Fit the washer
to hold the wheel in place and
secure with the split pin
.
NOTE: Bend the ends of the pin to prevent it from
falling out during use.
iv. Align the heater on the leg frame.
NOTE: Air inlet over the wheels.
v. Align the front and rear handles.
vi. With four of the bolts and nuts provided, sandwich the
upper handle, fuel tank lip and leg frame. The
remaining four bolts and nuts attach the handles to the
fuel tank lip only.
8.3 WHEELS (32284 & 53925)
i. Centralise the axle
before clamping it to the
underside of the fuel tank with brackets
.
ii. Secure with the nuts and bolts
provided.
Follow steps ii and iii above to complete the assembly.
FIG.1
FIG.2
FIG.3
11
