4. INTRODUCTION
4.1 SCOPE
The 20" fan described in this booklet is intended for air flow circulation use.
4.2 SPECIFICATION
Stock No. .................................................................................................................................. 09408
Part No. ..................................................................................................................................HV20F
Motor:
Rated voltage ........................................................................................................................230V
Rated frequency.....................................................................................................................50Hz
Rated input ...........................................................................................................................150W
No. of speeds .................................................................................................................................. 3
Dimensions (WxHxD) ....................................................................................... 570 x 520 x 1650mm
Weight (fan only) ........................................................................................................................ 11kg
4.3 HANDLING & STORAGE
This fan is designed to be moved to different locations. Ensure it is always operated on a firm and
stable surface. Ensure that water and/or cleaning detergent does not enter the motor housing or
switch mechanism.
- 12 -
- 5 -
9. FAN
INSTRUCTION
9.1 SWITCH OPERATION
The speed is controlled by rotating the switch located on the fan
motor housing:
0. OFF.
1. LOW.
2. MEDIUM.
3. HIGH.
Important:
Remove the plug from the power supply and wait until
the fan has completely stopped rotating before making any
adjustments to it.
9.2 AIR FLOW DIRECTION
1. To start/stop the fan head oscillating, push down/pull up the
oscillation action knob
.
2. The air flow can be adjusted upward or downward by
loosening the tilt adjustment knob
and adjusting the
vertical angle as desired. Re-tighten knob securely.
9.3 ADJUST HEIGHT OF FAN
To adjust the height of the fan, support the weight of the fan and
motor unit by holding the handle on the rear protective grille
while carefully unscrewing the lock knob on the column. Adjust
the fan to the required height and retighten lock knob,
ensuring fan is secure.
9.4 CLEANING INSTRUCTIONS
Note:
Remove the plug from the socket before carrying out
adjustment, servicing or maintenance.
Warning:
Ensure that the fan is switched off from the mains and
plug is disconnected from the power supply before removing the
grille.
1. To disassemble the fan, reverse the sequence of the ‘8.1
assembling the protective blade grilles’ section (page 11).
2. Clean components with a dry/damp soft cloth.
DO NOT
use
detergents/sprays as these will damage the motor/switch
assembly.
