FIG.8
FIG.9
- 9 -
OPERATION AND USE
- LED WORKLIGHT (Fig.8):
To aid drilling and screwdriving in confined,
inadequately lit spaces, the LED worklight
automatically illuminates when the trigger is
activated.
- SCREWDRIVER BIT HOLDER (Fig.7):
The drill comes equipped with a bit holder
(D)
on the
left side of the housing to hold the two screwdriver
bits supplied.
- HOLDING THE DRILL (Figs.9 & 10):
The drill casing is designed to be held comfortably in
two ways;
1. By the handle.
2. Or by the in-line support grip.
- DUST
AND
SWARF:
A correctly fitted dusk mask, suitable for the activity
and in accordance to the relevant standard, must be
worn.
For work activities involving exposure to fine wood
dust, a mask rated to at least FFP2 should be used.
Swarf produced by metal drilling is extremely sharp.
Take precautions when clearing swarf. The burr left on
the hole is also sharp and should be removed with a
suitable tool.
- DRILLING WOOD AND PLASTIC:
To prevent splitting around the drill holes on the
reverse side, place a piece of scrap timber under the
material to be drilled.
- DRILLING
METAL:
Metals such as sheet steel, aluminium and brass may
be drilled. Mark the point to be drilled with a centre
punch to help the drill bit tip to locate. A drop of oil
on the area will aid cutting and help the life of the bit.
- SCREWDRIVING:
To prevent slip or damage to the screwhead, match
the screwdriver bit to the screwhead size. To remove
screws, move the direction switch to the reversing
position and apply pressure to the screwhead and
depress the trigger slowly.
(D)
FIG.7
FIG.10
