1-2-10-1. STAND-ALONE OPERATION
At the stand-alone operation, the transmitter has a 30
seconds
ARM DELAY.
The door-open and shock sensor do not operate during ARM
DELAY.
1-2-10-2. OPERATION WITH CAR ALARM
The transmitter has a 5 seconds ARM DELAY in this
operation.
The door lock and door unlock will operate during ARM
DELAY.
1-3. INSTALLATION OF TRANSMITTER
1).Please connect all of input wires except BAT+, and then
connect BAT+.
All of inputs should be in the normal condition (Door
closed/Trunk
Closed/Shock
sensor
not-operated/START-IN
not-
operated/Door unlocked)
and then, BAT+ should be applied.
2).Please turn ON/OFF the more then 3 times during 5
seconds after BAT+
being applied, and then, the transmitter memorizes the
condition of
input lines whether it is positive input or negative
input. This
procedure should be done within 20 seconds after BAT+
being applied, otherwise the transmitter fetches the data
from memory after 20 seconds and acts by the data.
3).The ACC input and START-IN (REMOTE START) are always
positive input.
The
ARM_INPUT
is
used
to
determine
whether
the
transmitter is operated
STAND-ALONE or operated with CAR ALARM when installed.
4).OPERATION OF TRANSMITTER
• STAND-ALONE OPERATION
The transmitter will be operated STAND-ALONE when the
ARMED-
INPUT is grounded before BAT+ being applied. At this
mode, the
transmitter enters into ARM MODE when ACC INPUT is
removed and it enters into DISARM MODE when ACC INPUT
is applied.
• OPERATION WITH CAR ALARM
The transmitter will be operated with CAR ALARM
when the ARMED-
INPUT is floated or connected to the ARMED-OUTPUT of
