Repair Instructions for PCB CIO 8601051
1. What is needed?
a) Lithium battery- p/n 1835343
b) Buss wire- Kynar insulated 30awg buss wire or equivalent
c) ESD Kit (Electro-static discharge kit)
d) Soldering Iron (15 W w/ fine-tip)
e) Solder- Kester “44” Rosin core solder .031dia or equivalent
f) Side
cutters
g) Needle-nose
pliers
2. What is to be done?
Warning: This procedure should only be performed by professional technicians with
electronic soldering experience. If not performed properly, damage to the PCB may occur.
Warning: Electrostatic discharge can damage electronic components. When working on
electronic equipment use an anti-static mat and a wrist strap (ESD Kit).
1. Remove power to Julian.
2. Remove upper left back panel.
3. Locate and remove PCB CIO and place on ESD mat.
See Figure 1
.
Figure 1- CIO PCB Location
