DR SPRINT PRO, Руководство по безопасности и эксплуатации

Страница: 25 / 52

CONTACT US AT
www.DRpower.com
25
Wheels - SPRINT

and PRO Models
Tool needed:

5/8" Wrench
1. Block and stabilize the machine so that the Wheels are off the ground.
2. Loosen and remove the Locknut ( Figure 43 ).
3. Slide the Wheel off the Axle.
4. Reverse the steps to install the Wheel.
Wheels – PRO-XL SELF-PROPELLED Model
Tool needed:

5/8" Wrench
1. Block and stabilize the machine so that the Wheels are off the
ground.
2. Loosen and remove the Lock Nut ( Figure 44 ).
3. Turn the Wheel off the Axle, clockwise for the Right side Wheel and
counterclockwise for the Left side Wheel .
NOTE: Left and Right are determined from the Operator’s position.
4. Inspect the new Wheel Hub for markings ( Figure 45 ). The Wheel will
have a RED marking on one side and a BLACK marking on the other.
5. If you are installing a Wheel on the RIGHT side of the Mower, the
RED marking should face the body of the Mower. If you are
installing a Wheel on the LEFT, the BLACK marking should face the
body of the Mower.
6. Orient the Wheel so that the correct color marking faces toward the
body of the Mower.
7. Place the Wheel on the Axle and slowly turn the Wheel onto the Axle
(again, clockwise for the Right side Wheel and counterclockwise for the Left side Wheel .
The design of your trimmer is to power the wheels in the forward direction
only. Read and follow these directions and notes carefully when installing a
wheel.
Before performing any adjustment, maintenance procedure or inspection,
stop the engine, wait five (5) minutes to allow parts to cool and disconnect
the spark plug wire, keeping it away from the spark plug.
Before performing any adjustment, maintenance procedure or inspection,
stop the engine, wait five (5) minutes to allow parts to cool and disconnect
the spark plug wire, keeping it away from the spark plug.
Remove Locknut
Figure 43
Lock
Nut
Figure 44
Figure 45
Marking
on Wheel
Hub