DR Electric-Start - Self-Propelled, Руководство по безопасности и эксплуатации

Страница: 45 / 62

CALL TOLL FREE
1-800-DR-OWNER
41
Drive Chain Alignment/Tension
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, WAIT FIVE (5)
MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK PLUG WIRE, KEEPING IT AWAY
FROM THE SPARK PLUG.
Tools Needed:
•
7/16" Socket with 6" Extension
•
(2) 1/2" Wrench or Socket
•
Needle-Nosed Pliers
•
Flat Head Screwdriver
•
Pry Bar
1. Block up the machine so that the rear wheels are off the ground.
2. Remove the Belt Cover using a 7/16" Socket with a 6" Extension to remove the four (4) 1/4" Cover
Bolts ( Figure 21 on page 37).
3. Using two (2) 1/2" Wrenches or Sockets, loosen the left side (viewed from behind Handlebars)
Axle Bearing Mount Bolts and then slide the Bearing forward to the end of its travel ( Figure 24 ).
4. Rotate the Left Rear Wheel to bring the Drive Chain “Master Link” into view on the Axle Sprocket
( Figure 24 ).
5. Remove the Master Chain Link ( Figure 25 ). First, remove the Lock Clip by spreading the Clip with
the Screwdriver and at the same time, slide the Lock Clip back off the Master Link pins with the
Needle-Nosed Pliers. Next, remove the Side Plate, and then remove the Master Chain Link.
6. Slowly feed out the old Drive Chain and remove the Chain.
7. Thread the new Drive Chain onto the sprockets.
Tip: Place the ends of the Chain on the Axle Sprocket; this makes it easier to hold the Chain in place
when you slide the new Master Link in place.
Figure 24 Figure 25
Master Link
Side Plate
Lock Clip
Axle Bearing
Mount Bolt
(2 places)
Master Link
Forward