20
DR
®
WDS 6.3, 6 -TON ELECTRIC WOOD SPLITTER
Adjusting the Hydraulic Fluid Level
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST UNPLUG THE WOOD SPLITTER FROM THE
POWER SOURCE AND MAKE SURE THE HYDRAULIC SYSTEM IS DEPRESSURIZED AND THE FLUID HAS
COOLED. READ THE "GENERAL SAFETY RULES" (CHAPTER 2) OF THIS MANUAL BEFORE PERFORMING
ANY REPAIRS OR MAINTENANCE.
Tools Needed:
•
Adjustable Wrench
•
Small Phillips Screwdriver
1. Check the hydraulic fluid level by tipping the wood splitter up on the wheels and motor.
2. Clean the area around the Hydraulic Fluid Fill/Drain Port. It is important not to let any debris enter
the fluid reservoir; see
Figure 4
on page 14. Loosen the Bleed Screw and then, using the adjustable
wrench, unscrew the Dipstick located in the Hydraulic Fluid Fill/Drain Port.
3. Clean the Dipstick and replace without screwing down to check the level; it should be between the
two marks on the Dipstick. If the fluid is too high, simply pour out a little at a time into a suitable
container by tilting the wood splitter. If the fluid is too low, add an AW32 hydraulic fluid, a little at a
time, until the level falls between the two marks on the Dipstick.
4. Clean the Dipstick and the O-ring seal thoroughly and reinstall, being careful not to damage the
threads of the aluminum Hydraulic Fluid Cylinder End Cover.
5. Open the Air Bleed Screw using a small Phillips screwdriver 4 turns and cycle the Ram back and
forth 3 or 4 times to purge any air from the hydraulic system; see
Figure 3
on page 13.
Sharpening the Wedge
WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST UNPLUG THE WOOD SPLITTER FROM THE
POWER SOURCE AND MAKE SURE THE HYDRAULIC SYSTEM IS DEPRESSURIZED AND THE FLUID HAS
COOLED. READ THE "GENERAL SAFETY RULES" (CHAPTER 2) OF THIS MANUAL BEFORE PERFORMING
ANY REPAIRS OR MAINTENANCE.
Tool Needed:
•
Fine-Toothed Flat File
Before each splitting session, check the sharpness of the wedge. As required, remove any burrs or flat
spots on the wedge blade using a fine-toothed flat file.
Содержание 6-TON ELECTRIC WOOD SPLITTER
