DR. Z Amplification Remedy ZA-27, Руководство пользователя

Страница: 4 / 6

1. Power Indicator:
Lights up when power is switched on. If bulb fails replace with type T47.
2. Power: Switch up to turn on amplifier. Switch down to turn off amplifier.
3. Stand-By:
Leave in off position for 1 minute when powering up the amp. Turn on for play. Place in off
position for extended break periods.
4. Master: This is a (post phase inverter) master volume. Use this to control overall amp volume without
affecting your EQ and loudness settings.
5. Bass: Controls overall low frequency response.
6. Mid:
Controls overall mid frequency response.
7. Treble: Controls overall high frequency response.
8. Loudness I (High): This volume control has a higher treble response. Use this to achieve a clearer top end.
9. Loudness II (Normal):
This volume control will give you a much fuller sound. Use this to add thickness to
your tone.
10. Input:
Input jack for your guitar. This input jack feeds both volume controls (high/normal).
FRONT PANEL
REAR PANEL
12
13 14 16 15 17
11. EQ Bypass Footswitch Jack:
Plug supplied single button footswitch in here. This will enable you to
engage the EQ bypass/gain boost mode.
12. 4 OHM Speaker Jack: Plug in 4 ohm speaker here. Always have a speaker plugged into the amp
when it is powered on. Always match the speaker impedance to the proper speaker out jack. This will
allow the amp to sound its best and avoid damage.
13. 8 OHM Speaker Jack:
Plug in 8 ohm speaker here. Always have a speaker plugged into the amp
when it is powered on. Always match the speaker impedance to the proper speaker out jack. This will
allow the amp to sound its best and avoid damage.
14. 16 OHM Speaker Jack:
Plug in 16 ohm speaker here. Always have a speaker plugged into the amp
when it is powered on. Always match the speaker impedance to the proper speaker out jack. This will
allow the amp to sound its best and avoid damage.
15. Half/Full Power Switch: This switch allows you to play your amp at half (20 watts) or full (40 watts)
power.
16. Fuse:
The fuse protects the amp from electrical faults. Replace only with the same rating and type
stated below fuse holder. If the amp repeatedly blows the fuse contact your dealer or Dr Z Amps.
17. AC Inlet:
(Class I Wiring). This device is used for disconnection from power mains and must remain
readily opearable. The power indicator light does not indicate connection to power mains. The power
cord must be disconnected to disconnect amplifier from power mains.
11
2 3 4 5 6 7 8 9 10 1