DR Power Equipment WALK BEHIND BLOWER Premier, Руководство по безопасности и эксплуатации

Страница: 16 / 28

16
DR
®
WALK BEHIND BLOWER
7. Look closely at the Belt form the left side of the machine to find a small black
arrow (
Figure 22 ). The black arrow shows the direction of rotation. The
arrow would be pointing up when viewed from this left side of the machine.
The new Belt will need to be installed in the same direction for the Belt to
work properly.
Note: Another way to quickly tell what direction the Belt should be assembled is to
see what direction the “V” shaped opening is pointing. The “V” is pointing down
when viewed from the left side of the machine.
8. Cut the old Belt to be replaced using Diagonal Cutters or equivalent and
remove Belt from upper Engine Pulley (
Figure 21 ).
Note: You may want to practice assembling the Belt out of the machine before it is
in placed inside where there is limited access. See the following section “Assembling
the Belt Links”.
Assembling the Belt Links
This section explains the assembly of the Belt Links and is for reference when
installing the Belt onto the machine.
The Belt can be assembled by hand but if you are having difficulty twisting the
Tabs, Needle Nose Pliers can be used. Be careful not to damage the Tabs when
using the Pliers.
1. Turn the Belt inside out so the inside Tabs are facing out ( Figure 23 ).
2. Twist the Tab end sideways and insert it through the two Slots until it comes
out the other side (
Figure 24 ).
3. Twist the end of the Tab to lock it into position ( Figure 25 ).
4. Twist the second Tab sideways and insert it into the slot of the single Link at
the end.
5. Twist the Tab back to the locking position ( Figure 26 ).
6. Flip the Belt back to be right side out ( Figure 27 ).
Note:
The Belt must be disassembled before it can be installed around the Engine
Pulley in the next section.
First Tab
Figure 24
Two Link Layers
Black Arrow
Pointing Up
Figure 22
Link
Belt
“V” Opening
Pointing
Down
Right Side
Out
Figure 27
Straighten
First Tab To
Lock in Place
Figure 25
Second
Tab
Inside of
Link Belt
Figure 23
Assemble
with Tabs
facing Out
Outside of
Link Belt
Straighten
Second Tab
Figure 26