06
07
Maintenance
Transportation Climate and
environmental conditions
Transportation
Storage
Usage Method
1)
Battery& massage head
2)
3)
4)
Aim at the bottom slot of the device and insert the battery into it as shown in
Figure 1 below. Make sure that the battery is firmly fixed at the bottom of the
device (Fig. 2). There should be no gap between the battery and the fuselage (Fig.
3 is wrong).
When the equipment is closed, the massage head is fully inserted by pressure.
When the massage head is disassembled, it can be pulled out. (Pay attention to
safety: when installing the vibrating head, please insert it directly and pull it out.
No rotation is allowed).
To tear down the battery, one hand dials the battery lock key to the "unlock"
key, and the other hand pulls down the battery/handle.
Turn the power switch at the bottom of the battery to ON and start the
device; Switch the power card to OFF position and close the device.
When the power switch is in ON , press the " " touch key on
the panel and the gear will be switched between 0-5 gears. If the
" " touch key is pressed for 2 seconds, the output of the
instrument will stop immediately.
·
The LED light will indicate the frequency level of the corresponding hit times,
the lowest in Grade 1 and the highest in grade 5.
Apply the required pressure with the preset vibration massage
frequency to massage the corresponding body parts
.
Left:
Handle unlock
right:
Handle lock
Fig.
1
Fig.
2
Fig.
3
Crevice
Seamless
·
Clean the equipment with a slightly wet towel and dry it with a soft cloth;
·
If you do not use the equipment for a long time, please separate the battery from
the mainframe and store it in the box;
·
Do not disassemble the screw or attempt to disassemble the equipment;
·
In order to achieve the best use of new batteries in a short period of time,
complete charging and discharging can be carried out three or more times.
·
When the equipment is not used for a long time, the battery should be charged
once a month.
·
·
·
Temperature
：-
40℃
～＋
50℃
；
Relative humidity
：≤
90%
Barometric pressure
：
70kPa～106kPa；
·
·
·
This product is suitable for automobiles, trains, ships, airplanes and other modes
of transportation;
During transportation, it should be fixed to prevent violent vibration, collision, roll
and fall; and be upward, careful, light and rainproof;
No more than 5 layers of massager stacked.
·
Massage equipment should be stored in a well ventilated, non-corrosive gas
warehouse, 250 mm off the ground;
When massage instrument is not used for a long time, it should be packed and
stored after cleaning. It is better to take it out and recharge once a month to
prevent dampness.
·
No more than 5 layers of massager stacked;
·
DEEP MUSCLE MASSAGER
DEEP MUSCLE MASSAGER
