DR. BENDER 102248, Руководство по эксплуатации

Страница: 14 / 23

14
5.4 ESPADA attachment
5.4.1 Chain / blade change
Remove the side guard by loosening the two wing screws (1) on the console.
Loosen the hex nut (2) in the centre of the console until it can be turned by hand.
Turn the clamping screw (3) anticlockwise until the blade bears against
the drive wheel.
The old chain can now be removed from the blade tip.
When pulling on the new chain, make sure that the chain is first placed
around the drive wheel, then into the guide groove towards the blade tip.
The blade is now tensioned by turning the clamping screw (3)
clockwise. The chain tension should be set so that the chain is
taut but can still be moved by hand.
Tighten the hex nut (2) again.
The guard can then be pushed on again and fastened with wing screws
(1). Make sure that the plastic washers of the wing screws are not clamped between guard and console.
First remove the chain as described in 5.4.1.
Remove the hex nut (2) completely and pull the holding
plate from the blade.
The blade can now be easily removed from the console.
Place the new blade into the console. Make sure that the
clamping pins (4) are guided into the holes provided on the
blade.
Now insert the holding plate through the oval hole of the blade and insert the hex nut again (2), attach it by
hand.
Move the chain to insert and tension it as described in 5.4.1.
5.5 Saw blades
You can use any saw blade with a connection bore of 1 “ ( 25.4 mm) . Only use saw blades which are
suitable for the stone type. Using only concentric saw blades that are not deformed prolongs the service life
of the drive unit. Ensure that the diamond segments have an adequate undercut in relation to the saw
blade.