Pass the esc cables through the front of the fuselage,
the battery plug to the battery bay and the receiver
connection to the receiver bay in front of the battery.
Attach the motor box to the front of the fuselage with the
two screws and capture nuts supplied. Ensure the
direction of side thrust is pointing to the starboard side
of the plane.
Install the servos as shown and pass the servo wires
through to the receiver bay in front of the battery.
Connect the wires into the receiver as appropriate and
test servo movement and throttle.
WARNING - make sure your propeller is not attached
when testing.
Take the 2 x piano wire`s supplied and make the two
push rods as shown in the images. The V sections are
so you can mechanically trim the push rod to achieve a
neutral elevator and rudder position.
Put a Z-bend on the servo end only and ensure the
Z- bend is in the correct orientation to allow the V bends
to lay parallel.
Pass the push rods through the
fuselage ensuring they locate
through the two push rod supports.
The push rods cross over in the
fuselage to allow free movement.
Z-bend
Longest
plywood
side
Starboard
side
340mm
340mm
