34
opening of the bag as shown in figure 22 and in figure 23. At the end, the
device must be as in Figure 24.
i)
Partially close the zip (fig. 24) and, when it comes close enough, insert the free
end of the plastic fastener inside the hole of the internal fin of the zip and then pass it
through the ring of the
“V” shaped activation pin placed in the hole in the
valve/pressure reducer (fig. 25). Then engage the plastic fastener inserting the free end
in the corresponding slot at the other end. Pull the free end (and correspondingly slide
the zip in order to prevent tension which could actuate the air flow), until when the free
end of the fastener beyond the slot at the other end is 20 cm. long (fig.27). Cut and
throw away this free end
j)
Fully close the zipper and see through the transparent window that the gauge
needle is in the green sector, indicating a full charge of the cylinder as shown in figure
26.
k)
Insert and lock the new tamper seal in the hole which is at the end of the zipper
by paying attention that it overlaps the one on the bag.
l)
On completion of the above operations the product must appear as shown in
Figure 1.
Содержание 4342.8225
