P
ANDORA
(
REV-C
), www.dpcav.com
Page 3
©2007-2008 Jun-11-2008
Figure 5, HS-81 Wheel Top View
Figure 6, HS-81 Wheel Bottom View
Figure 7, Tilt Horn mounts to the Tilt Plate
3.
Install the Hitec HS-81 servo's nylon cross-arm wheel onto the chassis. This requires four 2-56
x 3/16" machine screws, 2-56 nuts, the two Servo wheel back plates (items 7 & 8), and
Threadlocker. The servo wheel’s four holes will need to be drilled out (.089" hole). If the
wheel’s holes do not line up with the chassis’s holes then rotate it 90 degrees. An ear on one
of the wheel back plates will need to be trimmed so that it does not interfere with the front
bulkhead.
4.
Using epoxy or solder, mount the tilt horn (item 13) to the tilt plate (item 9). Ensure that the two
parts are perpendicular and that the horn’s tab is flush with the plate’s slot.
